 The
4015's polar pattern is a wide cardioid (also known as hemisphere),
attenuating less to the sides and back than a traditional first order
cardioid. It is designed with a linear on-axis frequency response from 40
Hz (±2 dB) to 20 kHz (+3/-2 dB) at 60 cm, with a soft high frequency lift
from 10 to 15 kHz of max. 3 dB.
Giving supreme accuracy, definition and resolution - as the legendary 4011
series - the 4015 will offer you natural sounding recordings. If an omni
is too ambient and a cardioid is too narrow, the 4015 will be a perfect
fill-in. Finally, the 4015 has a richer bass response than the 4011 and
will therefore serve you well both in close-up work as well as diffuse
field tasks.
Type 4015 is phantom powered (P48), transformerless and can handle 158 dB
SPL peak before clipping occurs.
Recording vocals, supporting sections of an orchestra, miking a conference
panel, a percussion set-up or a grand piano is successfully done with a
few DPA 4015s. These are just a few examples of applications that will
please the 4015 owner.
| Specification |
|
Principle of operation:
Pressure gradient
Cartridge type:
19 mm (0.75 in) pre-polarised condenser
Power supply:
48 V Phantom power
Frequency range, ± 2 dB:
On-axis: 40 Hz to 20 kHz
Directional characteristics:
Wide Cardioid
Equivalent noise level A-weighted:
Typ. 19 dB(A) re. 20 µPa (max. 20 dB(A))
Sensitivity, nominal, ±2 dB:
10 mV/Pa; -40 dB re. 1 V/Pa unloaded (at 1 kHz)
Equiv. noise level ITU-R BS.468-4:
Typ. 25 dB (correct with the attenuator in 0 dB or -20 dB
setting)
Capsule diameter:
19 mm (0.75)
Total harmonic distortion (THD):
<0.5% up to 110 dB SPL peak
<1% up to 116 dB SPL peak
|
Preamplifier frequency
range:
20 Hz to 40 kHz -3 dB (loaded with 2x10 kOhm//
10 nF - equivalent to 100 m cable)
Output impedance:
<200 Ohm
Cable drive capability:
Up to 100 m (328 ft)
Microphone length:
175 mm (6.9 in)
Max. SPL, peak before clipping:
158 dB SPL (attenuator set to either 0 dB or -20 dB)
Weight:
165 g (5.8 oz)
Operating temperature range:
-10 to +55°C (+14 to 131°F)
Dynamic Range:
Typ. 97 dB
Switchable attenuator:
0 dB, -20 dB
S/N ratio, re. 1 kHz at 1 Pa (94 dB SPL):
75 dB(A)
Connector:
3-pin XLR-M (Standard P48)
|
|
